FoamFit Tools section divider

4 Nupla Hammer
KIT #119

Foam Organizer for 4 Nupla Hammers and 7 Mayhew Tools

larger image

Kits include both the tools and foam organizer.

This organizer is also available without tools: F1A-01526

FoamFit Tools section divider

Kit Description

4 Nupla Hammer Kit #119

This complete kit includes organizer insert F1A-01526, 4 Nupla Hammers, 1 Mayhew pry bar, and 6 Mayhew punches.

The tool organizer may be trimmed to fit a variety of drawer sizes. Please compare the minimum recommended size to your drawer size before ordering.

Detailed drawing: F1A-01526.pdf

made in the USA

Tool organizer made in USA. Tools made in USA.

1-Drawer Kit

Drawer Size
24 X 18 inches

$346.80 sale $281.40

Typically ships in about 1 week, but see current foam availability.

FoamFit Tools section divider

Tools Included with Kit

This kit includes the following 11 Nupla and Mayhew tools:

16 oz ball pein (Nupla 21-016)
16 oz soft face hammer (Nupla 11235, CBH-135)
16 oz claw hammer (Nupla 17-016)
2 lb dead blow (Nupla Power Drive 10025)
12 inch pry bar, 17 inch overall (Mayhew Dominator 60144)
center punch, 3/8 X 5 inch (Mayhew #415, size 3/8)
line-up punch, 5/32 X 9 (Mayhew 22011, #466, size 5/32)
cold chisel, 1/2 X 6 (Mayhew #70, size 1/2)
pin punch, 1/8 X 4-3/4 (Mayhew #413, size 1/8)
pin punch, 5/32 X 5 (Mayhew #413, size 5/32)
pin punch, 3/16 X 5-1/4 (Mayhew #413, size 3/16)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.

FoamFit Tools section divider

Drawer Requirements

The foam insert included with this kit measures 24 X 18 inches.

It is not possible to compress the foam because the tool pockets will also squeeze closed. The foam sheet can be trimmed with a sharp knife if necessary. Contact customer service if you'd like us to modify the sheet size to your measurements.

The minimum recommended size for trimming is 20-1/4 X 14-1/8 inches. This leaves a margin of approximately 1/4-inch. Trimmed organizers are not returnable.

FoamFit Tools section divider

Designer Notes

"We designed this kit for a facility that might occasionally need to open a crate while also working on machines and fixtures. We aimed for variety, including different types of hammers and punches. We didn't include many large hammers because we wanted it to fit in a typical bottom cabinet drawer. The pry bar and alignment punch should also come in handy."

FoamFit Tools section divider

How Kits are Packaged and Shipped

After test fitting each kit, we remove the tools and seal them in a heavy-duty bag for shipping. We include a drawing to help place each tool back in the foam.

FoamFit Tools section divider

back to kits with hammers

back to kits with tools main page

view the full selection of tool organizers for Nupla and Mayhew tools

FoamFit Tools section divider

FoamFit Tools Facebook Site FoamFit Tools YouTube Channel FoamFit Tools Pinterest Site