Fits the drive accessories and several other tools from the Husky 815-pc set H815MTSPO.
Fits (2) flex head ratchets, (2) palm ratchets, (13) extensions, (15) Long Hex Bit Sockets, (1) spinner handle, (3) breaker bars, (1) T-handle, (1) magnetic handle, and (72) screwdriver bits.
Drawer Size
31-1/2 X 17 inches
$79.00
larger image
note: tools are not included
Precision CNC-cut to fit 110 Husky tools:
drive tools:
1/4 X 2 extension
1/4 X 3 extension
1/4 X 6 extension
1/4-drive breaker bar
1/4-drive spinner handle
1/4-drive palm ratchet
3/8 X 1-1/2 extension
3/8 X 3 extension
3/8 X 6 extension
3/8 X 8 flex extension
3/8 X 10 extension
3/8 X 20 extension
3/8-drive breaker bar
3/8-drive flex-head ratchet
3/8-drive palm ratchet
1/2 X 3 extension
1/2 X 5 extension
1/2 X 10 extension
1/2 X 20 extension
1/2-drive breaker bar
1/2-drive flex-head ratchet
1/2-drive T-handle
long ball-end hex bit sockets:
(7) 3/8-drive hex bit socket sizes 1/8 to 3/8
(8) 3/8-drive hex bit socket sizes 3 to 10 mm
screwdriver bits:
magnetic handle
(6) nut driver bit sizes 1/4 to 1/2
(6) nut driver bit sizes 6 to 12 mm
(6) inch hex bits
(8) metric hex bits
(8) torx bits
(8) security torx bits
(9) slotted bits
(4) square bits
(13) Phillips bits
(4) pozi bits
This tool organizer was designed to fit the extensions and other drive tools from the Husky 815-pc set H815MTSPO. It also fits the long hex bit sockets and the screwdriver bits.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
31-1/2 X 17 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
27-15/16 X 16-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.