Foam Tool Organizer for
21 Craftsman Drive Tools with 3 Ratchets and a Breaker Bar

Overview

21 Craftsman Drive Tools with 3 Ratchets and a Breaker Bar

Fits all the drive accessories from the 21-pc set CMMT42283. Also fits 3 ratchets and 1 breaker bar.

Fits (13) extensions, (5) drive adapters, (3) swivels, (3) ratchets, and (1) breaker bar.

Only fits the newer version of the Craftsman 72-tooth ratchets.

Tool Notes

This tool organizer was designed to fit the 21-pc Craftsman drive tool set CMMT42283. It also has pockets for 3 Craftsman ratchets and a breaker bar. The pockets are sized to fit the newer version of the 21-pc set. The older version of the 21-pc set had a different model number and some of the adapters and swivels had different dimensions. It also fits the newer version of the 72-tooth ratchets. These ratchets have a pattern of diagonal lines marked on the handle, and the head is assembled with 2 screws. A previous version of the 72-tooth ratchets used the same model numbers, but the head was assembled using a snap ring.

Drawing

Drawing F-05313-R.pdf

Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.

Drawer Size

22-1/4 X 14-1/2 inches (inside width by inside depth)

Drawer Height

Works in most drawers, needing no more than 2 inches of vertical clearance.

Minimum Trimmable Size

It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:

21-1/4 X 12 inches

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Features and Benefits

• See what's missing at a glance.
• Anyone can return tools to the right spot.
• Closed-cell PE tool foam is durable and has great chemical resistance.

Standard Colors

Special Colors

We make these colors in smaller batches, but they are often in stock. Contact customer service to order.

Additional Information

Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.