Fits the wrenches from 16-pc set 86728.
Fits (16) wrench sizes from 8 to 25 mm.
Only fits the 90-tooth wrenches which are marked 90T.
Drawer Size
23-3/4 X 17-3/4 inches
$59.90
larger image
note: tools are not included
Precision CNC-cut to fit 16 GearWrench wrenches:
8 mm (GearWrench 86708)
9 mm (GearWrench 86709)
10 mm (GearWrench 86710)
11 mm (GearWrench 86711)
12 mm (GearWrench 86712)
13 mm (GearWrench 86713)
14 mm (GearWrench 86714)
15 mm (GearWrench 86715)
16 mm (GearWrench 86716)
17 mm (GearWrench 86717)
18 mm (GearWrench 86718)
19 mm (GearWrench 86719)
21 mm (GearWrench 86721)
22 mm (GearWrench 86722)
24 mm (GearWrench 86724)
25 mm (GearWrench 86725)
This tool organizer was designed to fit the flex-head wrenches from GearWrench set 86728. It only fits the GearWrench 90-tooth wrenches which are longer than their 72-tooth wrenches. The 90-tooth wrenches are marked 90T.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
23-3/4 X 17-3/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-3/4 X 15-1/2 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.