Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
90 Craftsman Metric Sockets
Overview
90 Craftsman Metric Sockets
Fits (23) 1/4-drive sockets,
(47) 3/8-drive sockets,
and (20) 1/2-drive sockets.
Accommodates all metric sockets from the 176-piece Craftsman socket set 34032.
Drawer Size
22-1/4 X 16-1/4 inches
$53.40
Details
- Drawer size: 22-1/4 X 16-1/4 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 90 Craftsman sockets:
(12) 1/4-drive 6-point sizes from 4 to 14
(11) 1/4-drive 6-point deep sizes from 4 to 14
(17) 3/8-drive 6-point sizes from 6 to 22
(11) 3/8-drive 12-point sizes from 9 to 19
(9) 3/8-drive 6-point deep sizes from 9 to 17
(10) 3/8-drive 12-point deep sizes from 9 to 18
(13) 1/2-drive 12-point sizes from 9 to 21
(7) 1/2-drive 6-point deep sizes from 13 to 21 (skips pocket for 16 mm)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the metric sockets from the Craftsman 176-piece set 34032. The pockets are sized to fit sockets with "U.S.A." markings.
Possible Modifications
Minimum trimmable size:
21-3/8 X 13-1/2 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1M-00271.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
