Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
21 Craftsman Metric Combination Wrenches, Fits non-USA Version 2
Overview
21 Craftsman Metric Combination Wrenches, Fits non-USA Version 2
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
Note: this organizer fits the metric combination wrenches from version 2 of the Craftsman 540-piece mechanics tool set (see Craftsman 35540).
Caution: see note about wrench length.
Drawer Size
22-1/4 X 16-1/4 inches
$53.40
Details
- Drawer size: 22-1/4 X 16-1/4 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 21 Craftsman metric combination wrenches:
metric wrench sizes: 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
Note about wrench length:
Some of the 540-piece sets produced under Craftsman model number 35540 have longer wrenches that will not fit in this organizer. Download the drawing below to check the fit, or measure the 13 mm combination wrench in your set. The length of the 13 mm wrench should be approximately 6-1/2 inches long.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the metric combination wrenches from version 2 of the Craftsman 540-piece set (see Craftsman 35540). The pockets are sized to fit tools that don't have "USA" markings.
Possible Modifications
Minimum trimmable size:
22 X 16 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1M-01045.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
