Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
8 Craftsman Metric Stubby Wrenches and 5 Flare-Nut Wrenches, Fits non-USA Wrenches
Overview
8 Craftsman Metric Stubby Wrenches and 5 Flare-Nut Wrenches, Fits non-USA Wrenches
Fits (8) metric stubby combination wrenches,
and (5) metric flare-nut wrenches.
Note: this organizer fits the metric stubby and flare-nut wrenches from the newer version of the Craftsman 540-piece mechanics tool set (see Craftsman 35540).
Drawer Size
11-1/2 X 16-1/4 inches
$35.00
Details
- Drawer size: 11-1/2 X 16-1/4 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 13 Craftsman wrenches:
metric stubby combination wrenches:
10mm (Craftsman 44113)
12mm (Craftsman 44114)
13mm (Craftsman 44115)
14mm (Craftsman 44116)
15mm (Craftsman 44117)
17mm (Craftsman 44118)
18mm (Craftsman 44119)
19mm (Craftsman 44120)
metric flare-nut wrenches:
9 X 11 (Craftsman 42095)
10 X 12 (Craftsman 42096)
13 X 14 (Craftsman 42097)
15 X 17 (Craftsman 42098)
16 X 18 (Craftsman 42099)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the metric stubby and flare-nut wrenches from version 2 of the Craftsman 540-piece set (see Craftsman 35540). The pockets are sized to fit tools that don't have "USA" markings.
Possible Modifications
Minimum trimmable size:
11 X 15-15/16 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1S-01055.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
