Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
26 Craftsman Metric Combination Wrenches
Overview
26 Craftsman Metric Combination Wrenches
Fits (16) raised-panel metric combination wrenches plus (10) ignition (midget) wrenches.
Note: this organizer fits all the combination wrenches from the Craftsman 26-piece set (see Craftsman 46936).
Caution: Recommended for a 3-inch or deeper drawer.
Will also fit older Craftsman combination wrenches with "U.S.A." markings.
Drawer Size
22-1/4 X 14-1/2 inches
$63.50
Details
- Drawer size: 22-1/4 X 14-1/2 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 26 Craftsman wrenches:
metric combination wrenches:
7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22
metric ignition (midget) wrenches:
4, 4.5, 5, 5.5, 6, 7, 8, 9, 10, 11
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the wrenches from the Craftsman 26-piece set 46936. The pockets will also fit older Craftsman combination wrenches with "U.S.A." markings.
Possible Modifications
Minimum trimmable size:
21-3/8 X 12-7/8 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1A-01168.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
