Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
40 Craftsman Hex Keys with 2 Pliers
Overview
40 Craftsman Hex Keys with 2 Pliers
Fits (11) short inch hex keys,
(9) long inch hex keys,
(11) short metric hex keys,
(9) long metric hex keys,
and (2) pliers.
Note: this organizer fits all the hex keys and pliers from the 413-piece mechanics tool set 33413.
Drawer Size
22-1/4 X 16-1/4 inches
$53.40
Details
- Drawer size: 22-1/4 X 16-1/4 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 40 Craftsman hex keys and 2 pliers:
short arm inch hex keys: .050, 1/16, 5/64, 3/32, 7/64, 1/8, 9/64, 5/32, 3/16, 7/32, 1/4
long arm inch hex keys: 5/64, 3/32, 7/64, 1/8, 9/64, 5/32, 3/16, 7/32, 1/4
short arm metric hex keys: 1.5, 2, 2.5, 3, 4, 4.5, 5, 5.5, 6, 7, 8
long arm metric hex keys: 1.5, 2, 2.5, 3, 4, 4.5, 5, 5.5, 6
pliers:
6-3/4" slip-joint 45378
6" long needle nose 45102
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the hex keys and pliers from Craftsman 413-piece set 33413.
Possible Modifications
Minimum trimmable size:
21-7/8 X 15-1/2 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1M-01170.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
