Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
29 Craftsman Screwdrivers Set #1
Overview
29 Craftsman Screwdrivers Set #1
Fits (12) slotted screwdrivers,
(9) Phillips screwdrivers,
(6) torx screwdrivers,
(1) pocket screwdriver,
and (1) offset screwdriver.
Accommodates 29 screwdrivers including 28-piece set 31797 plus one extra Phillips screwdriver (41297).
Drawer Size
22-1/4 X 14-1/2 inches
$49.80
Details
- Drawer size: 22-1/4 X 14-1/2 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 29 Craftsman screwdrivers:
slotted:
3/32 X 1-1/2, 1/8 X 2, 1/8 X 4, 3/16 X 1-1/2, 3/16 X 4, 3/16 X 6, 3/16 X 8, 3/16 X 9, 1/4 X 1-1/2, 1/4 X 4, 1/4 X 6, 1/4 X 8
Phillips:
P0 X 1-1/2, P0 X 2-1/2, P1 X 1-1/2, P1 X 3, P2 X 1-1/2, P2 X 4, P2 X 6, P2 X 8, P3 X 6
torx:
T10, T15, T20, T25, T27, T30
other:
1/4 X P2 combination offset, pocket screwdriver
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the 28-Piece Craftsman screwdriver set 31797, but has an additional pocket for a P3 X 6 Phillips screwdriver (41297).
Possible Modifications
Minimum trimmable size:
22 X 14-1/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1M-01275.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
