Fits (15) inch combination wrenches from 1/4 through 1-1/8.
Fits satin-finish or full-polish wrenches.
24 X 18 inches
note: tools are not included
Precision CNC-cut to fit 15 Wright wrenches:
1/4 (Wright 1108 or 1208)
5/16 (Wright 1110 or 1210)
3/8 (Wright 1112 or 1212)
7/16 (Wright 1114 or 1214)
1/2 (Wright 1116 or 1216)
9/16 (Wright 1118 or 1218)
5/8 (Wright 1120 or 1220)
11/16 (Wright 1122 or 1222)
3/4 (Wright 1124 or 1224)
13/16 (Wright 1126 or 1226)
7/8 (Wright 1128 or 1228)
15/16 (Wright 1130 or 1230)
1 (Wright 1132 or 1232)
1-1/16 (Wright 1134 or 1234)
1-1/8 (Wright 1136 or 1236)
This tool organizer fits the WrightGrip satin-finish or full-polish wrenches.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
24 X 18 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
22 X 16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.
For orders within the contiguous 48 US states.
Made in the USA!