Contact Us |
Drawing and Part Number Lookup
920-569-0140
7 Channellock Pliers with Wright Wire Stripper and Snap Ring Pliers
Fits (7) Channellock pliers, (1) Wright wire stripper, and (1) Wright retaining ring pliers.
May be trimmed to fit a variety of drawer sizes.
Only fits the older bent nose and linesman pliers.
Drawer Size
24 X 18 inches
$59.90
long reach (duckbill) pliers, 8 inch (Channellock 718)
cutting (diagonal) pliers, 7 inch (Channellock 437)
slip joint pliers, 7 inch (Channellock 546)
lineman's pliers, 7.25 inch (Channellock 347)
bent nose pliers, 5.75 inch (Channellock 386)
long nose pliers, 8.5 inch (Channellock 318)
tongue and groove plier, 9.5 inch (Channellock 420)
retaining ring pliers (Wright Tool 9H1234)
wire stripper/crimper/cutter (Wright Tool 9471)
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
20-7/8 X 13 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.