Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
7 Channellock Pliers with Updated Bent Nose and Linesman plus 2 Wright Pliers
Overview
7 Channellock Pliers with Updated Bent Nose and Linesman plus 2 Wright Pliers
Fits (7) Channellock pliers, (1) Wright wire stripper, and (1) Wright retaining ring pliers.
May be trimmed to fit a variety of drawer sizes.
Fits newer version of bent nose and linesman pliers.
Drawer Size
24 X 18 inches
$59.90
Details
- Drawer size: 24 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 9 Channellock and Wright pliers:
long reach (duckbill) pliers, 8 inch (Channellock 718)
cutting (diagonal) pliers, 7 inch (Channellock 437)
slip joint pliers, 7 inch (Channellock 546)
lineman's pliers, 7.5 inch (Channellock 367)
bent nose pliers with cutter, 8 inch (Channellock E388)
long nose pliers, 8.5 inch (Channellock 318)
tongue and groove pliers, 9.5 inch (Channellock 420)
retaining ring pliers (Wright Tool 9H1234)
wire stripper/crimper/cutter (Wright Tool 9471)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Possible Modifications
Minimum trimmable size:
20-7/8 X 13-11/16 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F1A-01731.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
