FoamFit Tools section divider

Foam Tool Organizer for
12 Craftsman Pliers with Pockets for Wire Stripper and 8-inch Linesman

see all organizers for pliers


12 Craftsman Pliers with Pockets for Wire Stripper and 8-inch Linesman

Fits (1) duck bill, (1) long reach, (2) long nose, (1) bent nose, (1) slip joint, (1) arc-joint, (2) diagonal cutters, (1) linesman, (1) wire stripper, and (1) retaining ring pliers.

Similar to F1M-01451, but with pocket for 8-inch linesman pliers.

Drawer Size
22-1/4 X 16-1/4 inches


FoamFit Tools section divider


8 inch duck bill (Craftsman 45087)
8 inch long reach (Craftsman 45085)
8 inch long nose (Craftsman 45103)
6 inch long nose (Craftsman 45102)
6-1/2 inch bent nose (Craftsman 45104)
6-3/4 inch slip joint pliers (Craftsman 45378)
9-1/2 inch arc joint pliers (Craftsman 45381)
6 inch diagonal cutter (Craftsman 45075)
7 inch diagonal cutter (Craftsman 45076)
8 inch linesman (Craftsman 45094)
internal/external retaining ring pliers (Craftsman 47412)
wire cutter/stripper pliers (Craftsman 73573)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.

Made in the USA!

Foam Organizer for 10 Craftsman Pliers with Craftsman Snap Ring Pliers and Craftsman Wire Strippers

note: tools are not included

Possible Modifications

Minimum trimmable size:

22 X 15-3/4 inches

Note: Trimmed organizers are not returnable.

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Colors by special request:

black/yellow, black/green, black/gray

contact customer service to order this organizer in a special color.


Please verify this organizer fits your tools before placing an order.

  1. Download the drawing:
  2. Print the pages of the drawing full size or 100% (not fit).
  3. Check that the printout is full size by measuring the border with a ruler.
  4. Assemble the pages and place the printed drawing in your toolbox drawer.
  5. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider

FoamFit Tools Facebook Site FoamFit Tools YouTube Channel FoamFit Tools Pinterest Site