Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
25 Husky Screwdrivers, Hard Handle Style, Version 1
Overview
25 Husky Screwdrivers, Hard Handle Style, Version 1
Fits (10) slotted screwdrivers, (7) Phillips screwdrivers, (5) torx screwdrivers, (2) offset screwdrivers, and (1) pocket screwdriver.
Accommodates the hard handle (butyrate) screwdrivers from the 25-pc Husky set 20210006.
Only fits the version where the handle is round nearest the blade.
Drawer Size
20-3/8 X 15-11/16 inches
$49.50
Details
- Drawer size: 20-3/8 X 15-11/16 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 25 Husky screwdrivers:
slotted:
3/32 X 1-1/2, 1/8 X 2, 1/8 X 4, 3/16 X 1-1/2, 3/16 X 4, 3/16 X 6, 3/16 X 8, 1/4 X 4, 1/4 X 6, 5/16 X 6
Phillips:
p0 X 1-1/2, p0 X 2-1/2, p1 X 1-1/2, p1 X 3, p2 X 4, P2 X 6, P2 X 8
torx:
T10, T15, T20, T25, T30
other:
7/32 X p1 combination offset
1/4 X p2 combination offset
pocket screwdriver
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the hard handle (butyrate) screwdrivers from the 25-pc Husky set 20210006. This verson of the screwdriver handle is round where the blade enters the handle.
Possible Modifications
Minimum trimmable size:
18-7/8 X 15-1/8 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-02555-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
