Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
5 Craftsman Hammers with Pry Bar and 6 Mayhew Punches
Overview
5 Craftsman Hammers with Pry Bar and 6 Mayhew Punches
Fits 8-oz and 16-oz ball pein hammers, plastic tipped hammer, dead blow hammer, new claw hammer, pry bar, and 6 Mayhew punches.
Drawer Size
22-1/4 X 14-1/2 inches
$49.80
Details
- Drawer size: 22-1/4 X 14-1/2 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 5 Craftsman hammers and 7 additional tools:
8-oz ball pein hammer (Craftsman 38463)
16-oz ball pein hammer (Craftsman 38465)
12-oz plastic tip hammer (Craftsman 38292)
20-oz steel claw hammer (Craftsman CMHT51423)
2-lb dead blow hammer (Craftsman 38394)
17 inch pry bar (Craftsman 43276)
3/8 X 5 inch center punch (Mayhew #415, size 3/8)
5/32 X 9 inch line-up punch, (Mayhew 22011, #466, size 5/32)
1/2 X 6 inch cold chisel (Mayhew #70, size 1/2)
1/8 X 4-3/4 inch pin punch (Mayhew #413, size 1/8)
5/32 X 5 inch pin punch (Mayhew #413, size 5/32)
3/16 X 5-1/4 inch pin punch (Mayhew #413, size 3/16)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the Craftsman steel claw hammer which was new in 2018.
Possible Modifications
Minimum trimmable size:
21-3/4 X 14-1/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-02769-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
