Fits (5) slotted screwdrivers, (5) Phillips screwdrivers, (1) ratcheting screwdriver, and (27) additional pieces.
Accommodates 12 pieces from screwdriver set CMHT65071 and 26 pieces from ratcheting screwdriver set CMHT68001.
Only fits the black and red handle screwdrivers sold by Lowes and other Craftsman dealers starting mid 2018.
Fits version with nut driver bits.
Drawer Size
22-1/4 X 10-5/8 inches
$41.40
larger image
note: tools are not included
Precision CNC-cut to fit 38 Craftsman tools:
slotted screwdrivers:
1/8 X 1-1/2 (precision/mini)
3/16 X 4 (Craftsman CMHT65061)
1/4 X 1-1/2 (Craftsman CMHT65058)
1/4 X 4 (Craftsman CMHT65059)
5/16 X 6 (Craftsman CMHT65063)
Phillips screwdrivers:
P0 X 1-1/2 (precision/mini)
P1 X 3 (Craftsman CMHT65052)
P2 X 1-1/2 (Craftsman CMHT65053)
P2 X 4 (Craftsman CMHT65054)
P3 X 6 (Craftsman CMHT65057)
other tools:
(1) offset screwdriver
(1) magnetizer/demagnetizer
(1) ratcheting/telescoping handle (from Craftsman set CMHT68001)
(18) screwdriver bits
(6) nut driver bits
(1) telescoping magnetic pick up tool
This tool organizer was designed to fit the 12-piece Craftsman screwdriver set CMHT65071 with black and red soft handles, plus the 26-piece ratcheting/telescoping screwdriver set CMHT68001. The pockets only fit screwdrivers sold by Lowes and other Craftsman dealers starting mid 2018.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 10-5/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
22 X 10-1/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.