Fits (7) inch wrenches from 3/8 through 3/4 and (10) metric wrenches from 10 to 19 mm.
Fits satin-finish or full-polish wrenches.
Designed for Wright sets 707 and 751.
Drawer Size
24 X 18 inches
$66.00
larger image
note: tools are not included
Precision CNC-cut to fit 17 Wright wrenches:
inch sizes:
3/8 (Wright 1112 or 1212)
7/16 (Wright 1114 or 1214)
1/2 (Wright 1116 or 1216)
9/16 (Wright 1118 or 1218)
5/8 (Wright 1120 or 1220)
11/16 (Wright 1122 or 1222)
3/4 (Wright 1124 or 1224)
metric sizes:
10 (Wright 11-10mm or 12-10mm)
11 (Wright 11-11mm or 12-11mm)
12 (Wright 11-12mm or 12-12mm)
13 (Wright 11-13mm or 12-13mm)
14 (Wright 11-14mm or 12-14mm)
15 (Wright 11-15mm or 12-15mm)
16 (Wright 11-16mm or 12-16mm)
17 (Wright 11-17mm or 12-17mm)
18 (Wright 11-18mm or 12-18mm)
19 (Wright 11-19mm or 12-19mm)
This tool organizer fits the WrightGrip satin-finish or full-polish wrenches. See Wright set 707 or 907 and Wright set 751. It may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
24 X 18 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-11/16 X 14-1/2 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.