Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
15 Wright Metric Combination Wrench Set #1
Overview
15 Wright Metric Combination Wrench Set #1
Fits (15) metric wrenches from 7 to 19, plus 21, and 22 mm.
May be trimmed to fit a variety of drawer sizes.
Fits satin-finish or full-polish wrenches.
Designed for Wright set 752 or 952.
Drawer Size
24 X 18 inches
$59.90
Details
- Drawer size: 24 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 15 Wright wrenches:
metric sizes:
7 (Wright 11-07mm or 12-07mm)
8 (Wright 11-08mm or 12-08mm)
9 (Wright 11-09mm or 12-09mm)
10 (Wright 11-10mm or 12-10mm)
11 (Wright 11-11mm or 12-11mm)
12 (Wright 11-12mm or 12-12mm)
13 (Wright 11-13mm or 12-13mm)
14 (Wright 11-14mm or 12-14mm)
15 (Wright 11-15mm or 12-15mm)
16 (Wright 11-16mm or 12-16mm)
17 (Wright 11-17mm or 12-17mm)
18 (Wright 11-18mm or 12-18mm)
19 (Wright 11-19mm or 12-19mm)
21 (Wright 11-21mm or 12-21mm)
22 (Wright 11-22mm or 12-22mm)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer fits the WrightGrip satin-finish or full-polish wrenches. See Wright set 752 or 952. It may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Possible Modifications
Minimum trimmable size:
18-3/4 X 14-1/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-02956-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
