Contact Us | Drawing and Part Number Lookup 920-569-0140
18 Wright Metric Combination Wrench Set #1
Fits (18) metric wrenches from 7 to 24 mm.
May be trimmed to fit a variety of drawer sizes.
Fits satin-finish or full-polish wrenches.
Designed for Wright set 758 or 958.
24 X 18 inches
7 (Wright 11-07mm or 12-07mm)
8 (Wright 11-08mm or 12-08mm)
9 (Wright 11-09mm or 12-09mm)
10 (Wright 11-10mm or 12-10mm)
11 (Wright 11-11mm or 12-11mm)
12 (Wright 11-12mm or 12-12mm)
13 (Wright 11-13mm or 12-13mm)
14 (Wright 11-14mm or 12-14mm)
15 (Wright 11-15mm or 12-15mm)
16 (Wright 11-16mm or 12-16mm)
17 (Wright 11-17mm or 12-17mm)
18 (Wright 11-18mm or 12-18mm)
19 (Wright 11-19mm or 12-19mm)
20 (Wright 11-20mm or 12-20mm)
21 (Wright 11-21mm or 12-21mm)
22 (Wright 11-22mm or 12-22mm)
23 (Wright 11-23mm or 12-23mm)
24 (Wright 11-24mm or 12-24mm)
This tool organizer fits the WrightGrip satin-finish or full-polish wrenches. See Wright set 758 or 958. It may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
22 X 15 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.