Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
15 Wright Inch Combination Wrench Set #2
Overview
15 Wright Inch Combination Wrench Set #2
Fits (15) inch wrenches from 5/16 through 1-1/8 plus 1-1/4.
May be trimmed to fit a variety of drawer sizes.
Fits satin-finish or full-polish wrenches.
Designed for Wright set 715 or 915.
Drawer Size
24 X 18 inches
$59.90
Details
- Drawer size: 24 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 15 Wright wrenches:
inch sizes:
5/16 (Wright 1110 or 1210)
3/8 (Wright 1112 or 1212)
7/16 (Wright 1114 or 1214)
1/2 (Wright 1116 or 1216)
9/16 (Wright 1118 or 1218)
5/8 (Wright 1120 or 1220)
11/16 (Wright 1122 or 1222)
3/4 (Wright 1124 or 1224)
13/16 (Wright 1126 or 1226)
7/8 (Wright 1128 or 1228)
15/16 (Wright 1130 or 1230)
1 (Wright 1132 or 1232)
1-1/16 (Wright 1134 or 1234)
1-1/8 (Wright 1136 or 1236)
1-1/4 (Wright 1140 or 1240)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer fits the WrightGrip satin-finish or full-polish wrenches. See Wright set 715 or 915. It may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Possible Modifications
Minimum trimmable size:
22-1/4 X 16-1/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-02962-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
