16 Tekton Screwdriver Set
Fits (8) slotted and (8) phillips screwdrivers from 16-pc sets 26759, DRV41217, or DRV43008.
May be trimmed to fit a variety of drawer sizes.
24 X 18 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 16 Tekton screwdrivers:
1/4 X 1-1/2 (Tekton 26621 or DHS30250)
1/8 X 4 (Tekton 26603 or DHS31125)
3/16 X 4 (Tekton 26613 or DHS31188)
1/4 X 4 (Tekton 26623 or DHS31250)
5/16 X 4 (Tekton 26633 or DHS31313)
3/16 X 8 (Tekton 26615 or DHS34188)
1/4 X 8 (Tekton 26625 or DHS34250)
5/16 X 8 (Tekton 26635 or DHS34313)
#2 X 1-1/2 (Tekton 26671 or DHP30002)
#0 X 4 (Tekton 26653 or DHP31000)
#1 X 4 (Tekton 26663 or DHP31001)
#2 X 4 (Tekton 26673 or DHP31002)
#3 X 4 (Tekton 26683 or DHP31003)
#1 X 8 (Tekton 26665 or DHP34001)
#2 X 8 (Tekton 26675 or DHP34002)
#3 X 8 (Tekton 26685 or DHP34003)
This organizer was designed to fit the 16 Tekton screwdrivers from old black oxide set 26759, new black oxide set DRV41217, or chrome set DRV43008.
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-11/16 X 14-3/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.