Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
10 Tekton Pliers
Overview
10 Tekton Pliers
Fits (5) pliers, (3) mini pliers, and (2) locking pliers.
May be trimmed to fit a variety of drawer sizes.
Caution: Recommended for a 2-3/8 inch or deeper drawer.
Drawer Size
24 X 18 inches
$59.90
Details
- Drawer size: 24 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit Tekton pliers:
6 inch 70-degree bent long nose pliers (Tekton PGF10406)
7 inch long nose pliers (Tekton PGF10007)
6-1/2 inch slip joint pliers (Tekton 37122)
7 inch diagonal cutting pliers (Tekton PCT00007)
10 inch groove joint pliers (Tekton 37524)
10 inch curved jaw locking pliers (Tekton PLK10010)
6 inch long nose locking pliers (Tekton PLK30006)
mini long nose pliers (Tekton PMN11001)
mini flat nose pliers (Tekton PMN21001)
mini diagonal cutting pliers (Tekton PMN54001)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
Possible Modifications
Minimum trimmable size:
18-1/4 X 14-7/16 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-03161-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
