Fits (49) inch sockets, (72) metric sockets, (3) 3/8-drive ratchets, 3/8 X 18 breaker bar, (2) extensions, and 3/8 swivel.
Accommodates the 3/8-drive sockets and drive tools from the Tekton 74-pc set SKT15311 plus several smaller sets.
Recommended for 3 min drawer height.
24 X 18 inches
note: tools are not included
Precision CNC-cut to fit 121 Tekton tools:
(15) 3/8-drive deep 6-point sizes from 1/4 to 1 inch
(15) 3/8-drive 6-point sizes from 1/4 to 1 inch
(19) 3/8-drive deep 6-point sizes from 6 to 24
(19) 3/8-drive 6-point sizes from 6 to 24
(9) 3/8-drive 12-point sizes from 5/16 to 3/4
(12) 3/8-drive 12-point sizes from 8-19
(2) 3/8-drive spark plug socket sizes 5/8 and 13/16
(8) 3/8-drive hex bit socket sizes 1/8 to 3/8
(10) 3/8-drive hex bit socket sizes 3 to 10
(12) 3/8-drive torx bit socket sizes T10 to T60
3/8-drive 90-tooth quick-release ratchet (Tekton SRH11108)
3/8-drive flex head bent ratchet (Tekton SRH33112)
3/8-drive stubby ratchet (Tekton SRH11104)
3/8-drive 18 inch breaker bar (Tekton SBH00118)
3/8-drive X 3 extension bar (Tekton SHA11103)
3/8-drive X 6 extension bar (Tekton SHA11106)
3/8-drive universal joint (Tekton SHA12101)
This tool organizer was designed to fit the 3/8-drive sockets, ratchet, and drive tools from the Tekton 74-pc set SKT15311. Also includes pockets for Tekton sets SHD99103, SHD91104, SHB91101, SHB91102, SHB91103 and tools: SRH33112, SRH11104, SHD15016, and SHD15021.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
24 X 18 inches (inside width by inside depth)
Recommended for a drawer with at least 3 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21 X 15-7/16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.
For orders within the contiguous 48 US states.
Made in the USA!