Contact Us |
Drawing and Part Number Lookup
920-569-0140
48 Eklind Hex and Torx Keys
Fits (22) hex keys in holders, (19) T-handle hex keys, and (7) Torx keys in holder.
Shown with Eklind hex key sets 13213 and 13609, Power-T sets 64808, and Torx set 10007.
Sized to fit long-version L-key sets and 9-inch Power-T sets. Additional sets with regular ends, ball ends, and bright finish may also be used.
Drawer Size
36-1/2 X 16-1/4 inches
$87.50
T-handle hex keys:
5/64, 3/32, 7/64, 1/8 , 9/64, 5/32, 3/16, 7/32, 1/4 , 5/16, 3/8
2, 2.5, 3, 4, 5, 6, 8, 10 mm
long hex keys in holder:
.050, 1/16, 5/64, 3/32, 7/64, 1/8 , 9/64, 5/32, 3/16, 7/32, 1/4 , 5/16, 3/8
1.5, 2, 2.5, 3, 4, 5, 6, 8, 10 mm
Torx keys in holder:
T10, T15, T20, T25, T27, T30, T40
This tool organizer was designed to fit long hex-L keys and 9-inch Power-T hex keys. Shown with Eklind sets 60811, 64808, 13213, 13609, and 10007.
35-5/8 X 13-7/8 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.