24 Eklind Metric Hex and Torx Keys
Fits (16) hex keys in holders and (8) T-handle hex keys.
Shown with Eklind hex key sets 10007, 13609 and Power-T set 64808.
Sized to fit long-version L-key sets and 9-inch Power-T sets. Additional sets with regular ends, ball ends, and bright finish may also be used.
22-1/4 X 16-1/4 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 25 Eklind Hex Keys:
T-handle hex keys:
2, 2.5, 3, 4, 5, 6, 8, 10 mm
long hex keys in holder:
1.5, 2, 2.5, 3, 4, 5, 6, 8, 10 mm
Torx keys in holder:
T10, T15, T20, T25, T27, T30, T40
This tool organizer was designed to fit long hex-L keys and 9-inch Power-T hex keys. Shown with Eklind sets 64808, 13609, and 10007.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-11/16 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.