Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
84 Tekton 1/2-drive Impact Sockets and 3 Drive Tools
Overview
84 Tekton 1/2-drive Impact Sockets and 3 Drive Tools
Fits (34) 1/2-drive inch impact sockets and (50) 1/2-drive metric impact sockets and (3) drive tools.
Accommodates the tools from the 87-pc Tekton set SID92407.
Caution: recommended for a 3-9/16 inch or deeper drawer.
Drawer Size
24 X 18 inches
$79.70
Details
- Drawer size: 24 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 87 Tekton tools:
(17) 1/2-drive 6-point sizes from 5/16 to 1-1/4 in
(17) 1/2-drive 6-point deep sizes from 5/16 to 1-1/4 in
(25) 1/2-drive 6-point sizes from 8 to 32 mm
(25) 1/2-drive 6-point deep sizes from 8 to 32 mm
1/2 X 3 impact extension (Tekton SIA21103)
1/2 X 10 impact extension (Tekton SIA21100)
1/2 -drive impact universal joint (Tekton SIA22102)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the Tekton 87-pc, 1/2-drive impact socket set SID92407.
Possible Modifications
Minimum trimmable size:
21-3/4 X 14-13/16 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-03833-T.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
