Fits (2) flex head ratchets, (2) palm ratchets, (13) extensions, (15) long hex bit sockets, (1) spinner handle, (5) breaker bars, and (1) T-handle.
Accommodates the drive tools and long hex bit sockets from the Husky 1025-pc set H1025MTS.
Drawer Size
33-13/16 X 19-3/4 inches
$102.00
larger image
note: tools are not included
Precision CNC-cut to fit 24 Husky drive tools and 15 hex bit sockets:
drive tools:
1/4-drive breaker bar
1/4 X 2 extension
1/4 X 3 extension
1/4 X 6 extension
1/4-drive spinner handle
1/4-drive palm ratchet
3/8-drive flex head ratchet
3/8-drive palm ratchet
3/8-drive breaker bar
3/8 X 1-1/2 extension
3/8 X 3 extension
3/8 X 6 extension
3/8 X 8 flex extension
3/8 X 10 extension
3/8 X 20 extension
1/2-drive flex head ratchet
1/2-drive X 14 inch breaker bar
1/2-drive X 24 inch breaker bar
1/2-drive T-handle
1/2-drive speeder breaker bar
1/2 X 3 extension
1/2 X 5 extension
1/2 X 10 extension
1/2 X 20 extension
long ball-end hex bit sockets:
(7) 3/8-drive sizes from 1/8 to 3/8
(8) 3/8-drive sizes from 3 to 10 mm
This tool organizer was designed to fit the flex head ratchets, palm ratchets, breaker bars, extensions, long hex bit sockets, and other drive tools from the Husky 1025-pc set H1025MTS.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
33-13/16 X 19-3/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
31-15/16 X 18-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.