20 Husky Screwdrivers and 4 Picks
Fits (8) slotted screwdrivers, (7) Phillips screwdrivers, (5) hard-handle torx screwdrivers, and (4) precision picks.
Accommodates the soft-handle screwdrivers from the Husky 15-pc set 246340150, torx screwdrivers from the Husky 5-pc set H5PCTORXSDS, and precision picks from set 60004H.
22-1/4 X 19-1/2 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 24 Husky tools:
1/8 X 2-1/2, 3/16 X 4, 3/16 X 6, 3/16 X 8, 1/4 X 4, 1/4 X 6, 5/16 X 6, 5/16 X 8
p0 X 1-1/2, p0 X 2-1/2, p1 X 3, p2 X 4, P2 X 6, P2 X 8, P3 X 6
T10 X 3
T15 X 3
T20 X 3
T25 X 4
T30 X 4
This tool organizer was designed to fit the soft-handle screwdrivers from the Husky 15-pc set 246340150, torx screwdrivers from the Husky 5-pc set H5PCTORXSDS, and precision picks from set 60004H. It was sized to fit a common US General Series 2 drawer size.
22-1/4 X 19-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-5/8 X 18-3/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.