Fits (6) slotted, (6) phillips, (4) torx, (1) pocket, (3) offset, (1) square screwdriver, (4) picks, and (8) torx keys.
Accommodates the screwdrivers and folding torx keys from the 543-pc mechanics set CMMT72000.
Drawer Size
22-1/4 X 16-1/4 inches
$55.20
larger image
note: tools are not included
Precision CNC-cut to fit 33 Craftsman tools:
slotted:
3/32 X 1-1/2
1/8 X 2-1/2 (CMHT65017)
3/16 X 4 (CMHT65021)
1/4 X 1-1/2 (CMHT65013)
1/4 X 4 (CMHT65014)
1/4 X 6 (CMHT65015)
Phillips:
P0 X 1-1/2
P0 X 2-1/2 (CMHT65000)
P1 X 3 (CMHT65002)
P2 X 1-1/2 (CMHT65003)
P2 X 4 (CMHT65004)
P2 X 6 (CMHT65005)
torx:
T10 X 3 (CMHT65035)
T15 X 3 (CMHT65036)
T20 X 3 (CMHT65037)
T25 X 4 (CMHT65038)
other tools:
(1) square #2 X 4 (CMHT65033)
(4) mini-picks
(3) offset screwdrivers
(1) pocket/keychain
(8) torx keys in folding set
This tool organizer was designed to fit a folding torx key set and all the screwdrivers from the Craftsman 543-pc set CMMT72000. The screwdrivers are the same as the Craftsman 25-pc screwdriver set CMHT65046.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 16-1/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21 X 14-1/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.