FoamFit Tools section divider

Foam Tool Organizer for
14 Craftsman T-handle Hex Keys with 33 Additional Hex Keys

see all organizers for Craftsman Hex Keys


14 Craftsman T-handle Hex Keys with 33 Additional Hex Keys

Fits (7) inch T-handle hex keys, (7) metric T-handle hex keys, (17) hex keys in folding sets, and (16) short hex keys in holders.

Accommodates the hex keys from the 543-pc mechanics set CMMT72000.

Drawer Size
22-1/4 X 16-1/4 inches


FoamFit Tools section divider


T-through handle hex keys:
3/32, 7/64, 1/8, 5/32, 3/16, 7/32, 1/4
2.5, 3, 4, 5, 6, 8, 10 mm

folding hex key sets:
9-pc inch folding hex key set
9-pc metric folding hex key set
8-pc short inch L-key set in holder
8-pc short metric L-key set in holder

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.

Made in the USA!

Foam Organizer for 14 Craftsman T-handle Hex Keys with 33 Additional Hex Keys

note: tools are not included

Tool Requirements

This tool organizer was designed to fit most of the hex keys from the Craftsman 543-pc set CMMT72000. It only fits the T-through handle hex keys that have black and red handles with a pattern of diagonal markings.

Possible Modifications

Minimum trimmable size:

21-3/4 X 14-1/4 inches

Note: Trimmed organizers are not returnable.

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Colors by special request:

black/yellow, black/green, black/gray

contact customer service to order this organizer in a special color.


Please verify this organizer fits your tools before placing an order.

  1. Download the drawing:
  2. Print the pages of the drawing full size or 100% (not fit).
  3. Check that the printout is full size by measuring the border with a ruler.
  4. Assemble the pages and place the printed drawing in your toolbox drawer.
  5. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider

FoamFit Tools Facebook Site FoamFit Tools YouTube Channel FoamFit Tools Pinterest Site