FoamFit Tools section divider

Foam Tool Organizer for
14 Craftsman Pliers with Black and Red Handles

see all organizers for Craftsman Pliers

Overview

14 Craftsman Pliers with Black and Red Handles

Fits (3) pliers, (3) groove joint pliers, (6) mini, and (2) locking pliers.

Accommodates the pliers from the 543-pc mechanics set CMMT72000.

Only fits the black and red handle tools sold by Lowes and other Craftsman dealers starting mid 2018.

Does not fit the black and red handle screwdrivers or TruGrip pliers sold by Sears.

Drawer Size
22-1/4 X 16-1/4 inches

$53.40



FoamFit Tools section divider

Details

6-inch slip-joint pliers (Craftsman CMHT81712)
6-inch diagonal cutter (Craftsman CMHT81646)
8-inch long nose pliers (Craftsman CMHT81645)
10-inch groove joint pliers (Craftsman CMHT81720)
12-inch groove joint pliers (Craftsman CMHT81721)
7-inch straight jaw locking pliers (Craftsman CMHT81725)
10-inch curved jaw locking pliers (Craftsman CMHT81726)
mini linesman pliers
mini diagonal cutter
mini end nipper
mini long nose pliers
mini bent nose pliers
mini needle nose pliers

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.



Made in the USA!

Foam Organizer for 14 Craftsman Pliers

note: tools are not included

Tool Requirements

This tool organizer was designed to fit all the pliers from the Craftsman 543-pc set CMMT72000. This newer generation of Craftsman pliers has black and red handles and some are marked with part numbers that start with "CMMT". Ten of these pliers are also available in smaller sets (CMHT82547, CMHT81716, and CMHT81727). This organizer does not fit the pliers with black and red handles sold by Sears.

Possible Modifications

Minimum trimmable size:

21-3/4 X 16 inches

Note: Trimmed organizers are not returnable.

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Colors by special request:

black/yellow, black/green, black/gray

contact customer service to order this organizer in a special color.

Drawing

Please verify this organizer fits your tools before placing an order.

  1. Download the drawing: www.FoamFitTools.com/product/F-04079-R.pdf
  2. Print the pages of the drawing full size or 100% (not fit).
  3. Check that the printout is full size by measuring the border with a ruler.
  4. Assemble the pages and place the printed drawing in your toolbox drawer.
  5. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider

FoamFit Tools Facebook Site FoamFit Tools YouTube Channel FoamFit Tools Pinterest Site