3 Craftsman 72-Tooth Ratchets with 116 Additional Tools
Fits (3) ratchets, (6) extensions, (2) adapters, (3) swivels, (1) magnetic handle, (1) spinner handle, (44) hex keys, (17) nut driver bits, and (42) screwdriver bits.
Accommodates the ratchets and drive accessories from the 308-piece mechanics tool set CMMT45938.
22-1/4 X 14-1/2 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 119 Craftsman ratchets and drive tools:
1/4-drive 72-tooth ratchet (Craftsman CMMT81747)
3/8-drive 72-tooth ratchet (Craftsman CMMT81748)
1/2-drive 72-tooth ratchet (Craftsman CMMT81749)
1/4-drive spinner handle (Craftsman CMHT65078)
3-inch extension bar, 1/4-drive (Craftsman CMMT43539)
6-inch extension bar, 1/4-drive (Craftsman CMMT43531)
3-inch extension bar, 3/8-drive (Craftsman CMMT44264)
6-inch extension bar, 3/8-drive (Craftsman CMMT44261)
3-inch extension bar, 1/2-drive (Craftsman CMMT44133)
6-inch extension bar, 1/2-drive (Craftsman CMMT44131)
1/4-drive universal joint (Craftsman CMMT99216)
3/8-drive universal joint (Craftsman CMMT99291)
1/2-drive universal joint (Craftsman CMMT99294)
3/8-drive to 1/4 socket adapter (Craftsman CMMT99292)
1/2-drive to 3/8 socket adapter (Craftsman CMMT99222)
(1) Magnetic handle bit driver
(8) inch nut driver bits from 3/16 to 1/2
(9) metric nut driver bits from 4 to 12 mm
(42) screwdriver bits in 4 holders
(8) short hex key sizes 1/16 to 1/4 in holder
(14) short and long hex key sizes 3/64 to 5/16 in holder
(8) short hex key sizes 1.5 to 6 mm in holder
(14) short and long hex key sizes 1.5 to 7 mm in holder
This tool organizer was designed to fit the ratchets, drive tools, hex keys, and screwdriver bits from the 308-pc Craftsman Mechanics Tool Set CMMT45938.
22-1/4 X 14-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-5/16 X 14 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.