14 Husky Non-Reversible Ratcheting Wrenches with 20 Ignition Wrenches
Fits (7) inch ratcheting wrenches, (10) inch ignition wrenches, (7) metric ratcheting wrenches, and (10) metric ignition wrenches.
Accommodates the ratcheting and ignition wrenches from the Husky 505-pc set H505MTSPO.
19-1/2 X 21-11/16 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 34 Husky wrenches:
inch non-reversible ratcheting:
inch ignition wrenches:
metric non-reversible ratcheting:
metric ignition wrenches:
This tool organizer was designed to fit the non-reversible ratcheting wrenches and the ignition wrenches from the Husky 505-pc set H505MTSPO.
19-1/2 X 21-11/16 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 19 X 20-11/16 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.