Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
10 Channellock Pliers Including Diagonal Pliers 337
Overview
10 Channellock Pliers Including Diagonal Pliers 337
Fits (10) Channellock pliers.
May be trimmed to fit a variety of drawer sizes.
Drawer Size
23-3/4 X 17-3/4 inches
$59.90
Details
- Drawer size: 23-3/4 X 17-3/4 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 10 Channellock pliers:
9-1/2 crimping pliers (Channellock 909)
7-inch cutting (diagonal) pliers (Channellock 337)
7-1/2 linesman pliers (Channellock 367)
6-1/2 slip joint pliers (Channellock 526)
6-inch long nose pliers (Channellock E326)
8-inch bent nose pliers (Channellock E388)
8-inch long reach (duckbill) pliers (Channellock 718)
9-1/2 tongue and groove pliers (Channellock 420)
8-inch retaining ring pliers (Channellock 927)
7-inch wire stripper for 10-20 AWG (Channellock 957)
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
We designed this pliers organizer to replace an eariler version. This version uses the 337 diagonal cutting pliers which is more widely available. It is trimmable to fit a smaller drawer than some of our other Channellock pliers organizers.
Possible Modifications
Minimum trimmable size:
21-15/16 X 13-1/2 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
Contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-04858-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
