FoamFit Tools section divider

Foam Tool Organizer for
13 Channellock Pliers Including Tongue and Groove 430X

see all organizers for Channellock tools

Overview

13 Channellock Pliers Including Tongue and Groove 430X

Fits (11) Channellock pliers, (1) adjustable wrench, and (1) tin snips.

May be trimmed to fit a variety of drawer sizes.

New!

Drawer Size
23-3/4 X 17-3/4 inches

$59.90



FoamFit Tools section divider

Details

9-1/2 crimping pliers (Channellock 909)
7-1/2 linesman pliers (Channellock 367)
7-inch cutting (diagonal) pliers (Channellock 337)
6-1/2 slip joint pliers (Channellock 526)
7-inch wire stripper for 10-20 AWG (Channellock 957)
8-inch long reach (duckbill) pliers (Channellock 718)
8-inch long nose pliers (Channellock E318)
8-inch bent nose pliers (Channellock E388)
6-inch bent nose pliers (Channellock E326)
8-inch retaining ring pliers (Channellock 927)
10-inch tin snips (Channellock 610TS)
8-inch adjustable wrench, 1-1/2 inch capacity (Channellock 8WCB)
10-inch Speedgrip straight jaw tongue and groove pliers (Channellock 430x)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.



Made in the USA!

Foam Organizer for 13 Channellock Tools

note: tools are not included

Tool Requirements

We designed this pliers organizer to replace an eariler version. This version fits the 337 diagonal cutting pliers which is more widely available. It includes a pocket for the new 10-inch Speedgrip pliers plus a tin snips and adjustable wrench.

Possible Modifications

Minimum trimmable size:

21-3/4 X 15-13/16 inches

Note: Trimmed organizers are not returnable.

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Colors by special request:

black/yellow, black/green, black/gray

Contact customer service to order this organizer in a special color.

Drawing

Please verify this organizer fits your tools before placing an order.

  1. Download the drawing: www.FoamFitTools.com/product/F-04859-R.pdf
  2. Print the pages of the drawing full size or 100% (not fit).
  3. Check that the printout is full size by measuring the border with a ruler.
  4. Assemble the pages and place the printed drawing in your toolbox drawer.
  5. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider

FoamFit Tools Facebook Site FoamFit Tools YouTube Channel FoamFit Tools Pinterest Site