Foam Tool Organizer for
34 Craftsman Drive Tools with 72-Tooth Ratchets and Breaker Bar

Overview

34 Craftsman Drive Tools with 72-Tooth Ratchets and Breaker Bar

Fits (3) ratchets, (1) breaker bar, (25) extensions, (3) swivels, and (6) drive adapters.

Accommodates all the drive tools from the 34-pc set CMMT53001 plus 4 additional tools.

Only fits the newer version of these ratchets where the head is assembled with 2 screws.

Tool Notes

This tool organizer was designed to fit the 34-piece Craftsman drive tool set CMMT53001 plus 3 ratchets and a breaker bar. This drive tool set was new in 2022 and older tools may not fit. Ratchet pockets only fit the newer version of the Craftsman 72-tooth ratchets with diagonal markings and 2 screws to assemble the ratchet head. Older versions had a larger head with a snap ring.

Drawing

Drawing F-05069-R.pdf

Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.

Drawer Size

22-1/4 X 16-1/4 inches (inside width by inside depth)

Drawer Height

Works in most drawers, needing no more than 2 inches of vertical clearance.

Minimum Trimmable Size

It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:

21-3/4 X 15-7/8 inches

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Features and Benefits

• See what's missing at a glance.
• Anyone can return tools to the right spot.
• Closed-cell PE tool foam is durable and has great chemical resistance.

Standard Colors

Special Colors

We make these colors in smaller batches, but they are often in stock. Contact customer service to order.

Additional Information

Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.