Fits (22) metric combination wrenches from 5.5 to 32 mm plus (8) stubby wrenches.
Accommodates the metric combination and stubby wrenches from the Husky 1025-pc set H1025MTS.
Drawer Size
31-1/2 X 17 inches
$81.80
larger image
note: tools are not included
Precision CNC-cut to fit 30 Husky wrenches:
combination wrenches:
5.5 (HCW55MM)
6 (HCW6MM)
7 (HCW7MM)
8 (HSPW8MM)
9 (HSPW9MM)
10 (HSPW10MM)
11 (HSPW11MM)
12 (HSPW12MM)
13 (HSPW13MM)
14 (HSPW14MM)
15 (HSPW15MM)
16 (HCW16MM)
17 (HSPW17MM)
18 (HCW18MM)
19 (HSPW19MM)
21 (HCW21MM)
22 (HCW22MM)
24 (HCW24MM)
25 (HCW25MM)
27 (HCW27MM)
30 (HCW30MM)
32 (HCW32MM)
stubby wrenches:
9 (HSTW9MM)
10 (HSTW10MM)
11 (HSTW11MM)
12 (HSTW12MM)
13 (HSTW13MM)
14 (HSTW14MM)
15 (HSTW15MM)
18 (HSTW18MM)
This organizer was designed to fit the metric combination and stubby wrenches from the Husky 1025-pc set H1025MTS or H1025MTSPO.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
31-1/2 X 17 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
31 X 16-5/8 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.