Fits (2) flex head ratchets, (2) palm ratchets, (13) extensions, (15) long hex bit sockets, (1) spinner handle, (5) breaker bars, (1) T-handle, and (80) hex keys.
Accommodates drive tools, long hex bit sockets, and hex keys from the Husky 1025-pc set H1025MTS.
31 X 21-5/8 inches
note: tools are not included
Precision CNC-cut to fit 119 Husky tools:
1/4-drive breaker bar
1/4 X 2 extension
1/4 X 3 extension
1/4 X 6 extension
1/4-drive spinner handle
1/4-drive palm ratchet
3/8-drive flex head ratchet
3/8-drive palm ratchet
3/8-drive breaker bar
3/8 X 1-1/2 extension
3/8 X 3 extension
3/8 X 6 extension
3/8 X 8 flex extension
3/8 X 10 extension
3/8 X 20 extension
1/2-drive flex head ratchet
1/2-drive X 14 inch breaker bar
1/2-drive X 24 inch breaker bar
1/2-drive speeder breaker bar
1/2 X 3 extension
1/2 X 5 extension
1/2 X 10 extension
1/2 X 20 extension
Long Ball-End Hex Bit Sockets:
(7) 3/8-drive sizes from 1/8 to 3/8
(8) 3/8-drive sizes from 3 to 10 mm
Hex Keys in Holders:
10-pc inch short arm (HSAHKS10PCN)
13-pc inch long arm (HLAHKS13PC)
10-pc metric short arm (HSAHKM10PCN)
13-pc metric long arm (HLAHKM13PC)
Folding Hex Key Sets:
9-pc inch (HFHKS9PC)
8-pc metric (HFHKM8PC)
9-pc mini inch (HMFHKSM17PCN)
8-pc mini metric (HMFHKSM17PCN)
This tool organizer was designed to fit the flex head ratchets, palm ratchets, breaker bars, extensions, and more drive tools from the Husky 1025-pc set H1025MTS or H1025MTSPO. It also fits the long hex bit sockets and hex keys.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
31 X 21-5/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
30-3/8 X 21 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.
For orders within the contiguous 48 US states.
Made in the USA!