Fits 19 ratchets from the 24-pc set CMMT86901.
Fits (3) ratchets, (3) mini-head ratchets, (2) long ratchets, (3) bi-material ratchets, (2) swival-head ratchets, and (6) flex-head ratchets.
Does not include pockets for breaker bars or speeder handles.
Recommended for 2-1/8 min drawer height.
Drawer Size
22-1/4 X 16-1/4 inches
$73.40
larger image
note: tools are not included
Precision CNC-cut to fit 19 Craftsman ratchets:
72-tooth:
1/4 (Craftsman CMMT81747)
3/8 (Craftsman CMMT81748)
1/2 (Craftsman CMMT81749)
mini-head:
1/4 (Craftsman CMMT99423)
3/8 (Craftsman CMMT99442)
1/2 (Craftsman CMMT99431)
long ratchets:
3/8 (Craftsman CMMT99427)
1/2 (Craftsman CMMT99441)
bi-material ratchets:
1/4 (Craftsman CMMT99424)
3/8 (Craftsman CMMT99428)
1/2 (Craftsman CMMT99432)
swival-head ratchets:
1/4 (Craftsman CMMT99421)
3/8 (Craftsman CMMT99422)
flex-head ratchets:
3/8 bent flex head (Craftsman CMMT99439)
3/8 stubby flex head (Craftsman CMMT99425)
3/8 flex head (Craftsman CMMT99420)
3/8 long flex head (Craftsman CMMT99426)
1/2 flex head (Craftsman CMMT99429)
1/2 long flex head (Craftsman CMMT99430)
This tool organizer was designed to fit the ratchets from the 24-piece Craftsman drive tool set CMMT86901. Pockets for the 3 breaker bars and 2 speeder handles are not included. All ratchets in this organizer are the newer style which can be identified by a pattern of diagonal lines and part numbers that start with "CMMT".
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 16-1/4 inches (inside width by inside depth)
Recommended for a drawer with at least 2-1/8 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
22 X 16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.