Fits 10-pc screwdriver set 246340100, 4-pc pliers set 90153, 3-pc mini pliers set 90149, and 2 extra tools.
Fits (6) slotted screwdrivers, (5) Phillips screwdrivers, (5) pliers, and (3) mini pliers.
Only fits the soft-handle screwdrivers with black handles.
19-1/2 X 21-11/16 inches
note: tools are not included
Precision CNC-cut to fit 19 Husky tools:
P3 X 6 (Husky 210606440)
P2 X 6
P2 X 4
P1 X 3
P0 X 2-1/2
5/16 X 6
1/4 X 6
1/4 X 4
3/16 X 6
3/16 X 4
1/8 X 2-1/2
8-inch long nose
8-inch slip joint
10-inch groove joint
8-inch 6-in-1 multi-function (Husky 99999)
mini long nose
mini end cutter
This tool organizer was designed to fit a 10-piece Husky screwdriver set plus one extra Phillips screwdriver and a variety of pliers. It fits the black soft-handle screwdrivers (set 246340100) plus a P3 X 6 screwdriver (model 210606440). It also fits 4-pc pliers set 90153, 3-pc mini pliers set 90149, and the 8-inch, 6-in-1 wire strippers (model 99999). The foam is sized for a drawer in the Husky 46-inch toolbox. Toolbox drawer sizes are frequently changed by the manufacturers, so please measure your drawer before ordering.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
19-1/2 X 21-11/16 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
18-5/8 X 21-1/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.
For orders within the contiguous 48 US states.
Made in the USA!