Fits the 24-pc set CMMT86901.
Fits (3) ratchets, (3) mini-head ratchets, (2) long ratchets, (3) bi-material ratchets, (2) swival-head ratchets, (6) flex-head ratchets, (3) breaker bars, and (2) speeder handles.
Recommended for 2-1/8 min drawer height.
34 X 22 inches
note: tools are not included
Precision CNC-cut to fit 24 Craftsman tools:
1/4 (Craftsman CMMT81747)
3/8 (Craftsman CMMT81748)
1/2 (Craftsman CMMT81749)
1/4 (Craftsman CMMT99423)
3/8 (Craftsman CMMT99442)
1/2 (Craftsman CMMT99431)
3/8 (Craftsman CMMT99427)
1/2 (Craftsman CMMT99441)
1/4 (Craftsman CMMT99424)
3/8 (Craftsman CMMT99428)
1/2 (Craftsman CMMT99432)
1/4 (Craftsman CMMT99421)
3/8 (Craftsman CMMT99422)
3/8 bent flex head (Craftsman CMMT99439)
3/8 stubby flex head (Craftsman CMMT99425)
3/8 flex head (Craftsman CMMT99420)
3/8 long flex head (Craftsman CMMT99426)
1/2 flex head (Craftsman CMMT99429)
1/2 long flex head (Craftsman CMMT99430)
3/8 X 10 breaker bar (Craftsman CMMT44363)
1/2 X 15 breaker bar (Craftsman CMMT44201)
1/2 X 18 breaker bar (Craftsman CMMT44202)
3/8-drive speeder handle (Craftsman CMMT44271)
1/2-drive speeder handle (Craftsman CMMT44161)
This tool organizer was designed to fit the 24-piece Craftsman drive tool set CMMT86901. All ratchets in this organizer are the newer style which can be identified by a pattern of diagonal lines and part numbers that start with "CMMT". The foam sheet is oversized so it can be trimmed to fit a variety of drawer sizes.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
34 X 22 inches (inside width by inside depth)
Recommended for a drawer with at least 2-1/8 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
29-7/16 X 18-11/16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.
For orders within the contiguous 48 US states.
Made in the USA!