Fits the metric ratcheting wrenches from the Husky 815-pc set H815MTSPO.
Fits (15) non-reversible ratcheting wrenches, (7) flex-head ratcheting wrenches, and (6) reversible ratcheting wrenches.
Drawer Size
31-1/2 X 17 inches
$81.80
larger image
note: tools are not included
Precision CNC-cut to fit 28 Husky wrenches:
non-reversible ratcheting wrenches:
8 mm (HRW8MM)
9 mm (HRW9MM)
10 mm (HRW10MM)
11 mm (HRW11MM)
12 mm (HRW12MM)
13 mm (HRW13MM)
14 mm (HRW14MM)
15 mm (HRW15MM)
16 mm (HRW16MM)
17 mm (HRW17MM)
18 mm (HRW18MM)
19 mm (HRW19MM)
20 mm (HRW20MM)
21 mm (HRW21MM)
22 mm (HRW22MM)
flex-head ratcheting wrenches:
8 mm
9 mm
10 mm (HFRW10MM)
12 mm (HFRW12MM)
13 mm (HFRW13MM)
14 mm (HFRW14MM)
15 mm (HFRW15MM)
reversible ratcheting wrenches:
9 mm
10 mm (HRRW10MM)
12 mm (HRRW12MM)
13 mm (HRRW13MM)
14 mm (HRRW14MM)
15 mm (HRRW15MM)
This tool organizer was designed to fit the metric reversible, non-reversible, and flex-head ratcheting wrenches from the Husky 815-pc set H815MTS or H815MTSPO.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
31-1/2 X 17 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
30-7/8 X 16-3/16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.