Fits the screwdrivers from the 428-pc master technician set.
Fits (6) Phillips screwdrivers, (4) slotted screwdrivers, (1) screw holder, and (1) magnetic handle.
Drawer Size
12-1/8 X 19-1/2 inches
$42.60
larger image
note: tools are not included
Precision CNC-cut to fit 12 Quinn screwdrivers:
P0 X 1-1/2
P0 X 2-1/2
P1 X 3
P2 X 4
P2 X 6
P3 X 6
1/8 X 2-1/2
3/16 X 4
1/4 X 4
5/16 X 6
5/32 X 4 screw holder
magnetic bit driver handle
This tool organizer was designed to fit the screwdrivers from the Quinn 428-pc set 58154. The foam is sized to fit the 44-inch Series 2 US General toolbox.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
12-1/8 X 19-1/2 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
11-3/8 X 19-1/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.