Fits the 19-pc reversible, 12-point ratcheting combination wrench set.
Fits (19) metric wrenches from 6 to 24 mm.
Only fits the newer version with a satin finish and reversing levers.
Drawer Size
23-3/4 X 17-3/4 inches
$64.40
larger image
note: tools are not included
Precision CNC-cut to fit 19 Tekton wrenches:
6 mm (Tekton WRC23406)
7 mm (Tekton WRC23407)
8 mm (Tekton WRC23408)
9 mm (Tekton WRC23409)
10 mm (Tekton WRC23410)
11 mm (Tekton WRC23411)
12 mm (Tekton WRC23412)
13 mm (Tekton WRC23413)
14 mm (Tekton WRC23414)
15 mm (Tekton WRC23415)
16 mm (Tekton WRC23416)
17 mm (Tekton WRC23417)
18 mm (Tekton WRC23418)
19 mm (Tekton WRC23419)
20 mm (Tekton WRC23420)
21 mm (Tekton WRC23421)
22 mm (Tekton WRC23422)
23 mm (Tekton WRC23423)
24 mm (Tekton WRC23424)
This tool organizer was designed to fit the Tekton19-pc metric reversible ratcheting wrench set. Model numbers for this set are WRC94003, WRC94303, or WRC94403. Fits metric wrenches from 6 mm to 24 mm. Only fits the newer version with a satin chrome finish which has been available since early 2024. Reversible ratcheting wrenches have a 15-degree offset and a small lever to reverse the direction.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
23-3/4 X 17-3/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-3/4 X 16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.