Foam Tool Organizer for
7 Tekton Ball Pein and Flat Face Dead Blow Hammers

Overview

7 Tekton Ball Pein and Flat Face Dead Blow Hammers

Fits dead blow set HDB93001 and ball pein set HDB95002 plus 1 additional hammer.

Fits (3) dead blow hammers, (3) ball pein hammers, and (1) flat steel face hammer.

Recommended for 3 min drawer height.

New!

Drawer Size
23-3/4 X 17-3/4 inches

$85.60



Foam Organizer for 7 Tekton Ball Pein and Flat Face Dead Blow Hammers

larger image

Foam Organizer for 7 Tekton Ball Pein and Flat Face Dead Blow Hammers

larger image

note: tools are not included

Tool List

Precision CNC-cut to fit 7 Tekton hammers:

from 3-pc set HDB93001:
13 oz dead blow hammer (Tekton HDB30013)
21 oz dead blow hammer (Tekton HDB30021)
39 oz dead blow hammer (Tekton HDB30039)

from 3-pc set HDB95002:
36 oz ball pein hammer (Tekton HDB50036)
43 oz short ball pein hammer (Tekton HDB51043)
50 oz long ball pein hammer (Tekton HDB50050)

26 oz flat steel face hammer (Tekton HDB40026)

Tool Notes

This tool organizer was designed to fit the Tekton 3-pc dead blow hammer set HDB93001 and the 3-pc ball pein hammer set HDB95002. It also fits a 26-oz flat steel face hammer HDB40026. All of these Tekton hammers have shot-filled heads and are made in the USA.

Drawing

Drawing F-05728-T.pdf

Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.

Drawer Size

23-3/4 X 17-3/4 inches (inside width by inside depth)

Drawer Height

Recommended for a drawer with at least 3 inches of vertical clearance.

Minimum Trimmable Size

It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:

21-1/2 X 15-13/16 inches

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Features and Benefits

Standard Colors

black over red color combination blue over yellow color combination black over blue color combination

Special Colors

We make these colors in smaller batches, but they are often in stock. Contact customer service to order.

black over yellow color combination black over green color combination black over gray color combination

Additional Information

Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.

Free Shipping!

For orders within the contiguous 48 US states.

US flag

Made in the USA!