Fits the 14-pc combination wrench set and the 8-pc flex head ratcheting wrench set.
Fits combination wrenches from 1/4 to 1 and flex head wrenches from 5/16 to 3/4.
Fits open ends with or without the anti-slip grip.
Drawer Size
22-1/4 X 19-3/8 inches
$65.90
larger image
note: tools are not included
Precision CNC-cut to fit 22 Icon wrenches:
Set WCS-14 (64710) or WCAS-14 (64711)
1/4
5/16
11/32
3/8
7/16
1/2
9/16
5/8
11/16
3/4
13/16
7/8
15/16
1
Flex-head set WRFS-8 (56428)
5/16
3/8
7/16
1/2
9/16
5/8
11/16
3/4
This tool organizer was designed to fit the 14-pc Icon professional combination wrench set WCS-14 (64710). The anti-slip grip set WCAS-14 (64711) will also fit. Stubby or long wrenches will not fit. The ratcheting wrenches are Icon professional flex ratcheting set WRFS-8 (56428). The foam is sized for the US General 27 or 42-inch Series 3 boxes, but measure before ordering because drawer sizes vary.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 19-3/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
22 X 18-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.