Fits two 14-pc combination wrench sets plus the 5-pc large metric set.
Fits inch wrenches from 1/4 to 1.
Fits metric wrenches from 6 to 24 mm.
Drawer Size
37-1/8 X 19-3/8 inches
$109.90
larger image
note: tools are not included
Precision CNC-cut to fit 31 Icon wrenches:
Set WCS-14 (64710) or WCAS-14 (64711)
1/4
5/16
11/32
3/8
7/16
1/2
9/16
5/8
11/16
3/4
13/16
7/8
15/16
1
Set WCM-14 (64709) or WCAM-14 (64712)
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Large set WCM-5 (64803)
20
21
22
23
24
This tool organizer was designed to fit three Icon combination wrench sets. We started with two 14-pc Icon professional combination wrench sets, then added 5 larger metric wrenches to extend the range up to 24mm. The SAE set is WCS-14 (64710), but the anti-slip grip version WCAS-14 (64711) will also fit. The first metric set needed is WCM-14 (64709) or WCAM-14 (64712). The second metric set is the 5-pc professional large wrench set WCM-5 (64803). The foam was designed for the 2nd drawer of the US General 42-inch Series 3 rolling cabinet.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
37-1/8 X 19-3/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
35-7/8 X 18-3/16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.