Fits the 7-pc SAE and 10-pc metric ratcheting wrench sets.
Fits wrenches from 3/8 to 3/4 and 10 to 19 mm.
Only fits wrenches that have reversing levers.
Wrench sizes are laser marked on the foam.
Drawer Size
12-3/16 X 19-3/8 inches
$67.40
larger image
note: tools are not included
Precision CNC-cut to fit 17 Icon wrenches:
Set WRS-7 (64842)
3/8
7/16
1/2
9/16
5/8
11/16
3/4
Set WRM-10 (64841)
10
11
12
13
14
15
16
17
18
19
This tool organizer was designed to fit the Icon professional ratcheting wrenches. These are reversible ratcheting wrenches and are longer than their flex-head wrenches. The SAE set is Icon WRS-7 (64842), and the metric set is Icon WRM-10 (64841). The foam is sized for a narrow drawer found in several US General Series 3 boxes, but measure before ordering because drawer sizes vary. The wrench sizes are laser marked on the foam.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
12-3/16 X 19-3/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
11-11/16 X 18-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.