Fits three 3/8-drive SAE socket sets.
Fits the 12-pc shallow set, 12-pc semi-deep set, and 12-pc deep set.
Sizes are permanently laser marked on the foam.
Recommended for 3-1/4 min drawer height.
Drawer Size
6-1/2 X 11-1/2 inches
$32.40
larger image
note: tools are not included
Precision CNC-cut to fit 36 Icon sockets:
Shallow Set S2SS-12 (58103)
1/4
5/16
11/32
3/8
7/16
1/2
9/16
5/8
11/16
3/4
13/16
7/8
Semi-Deep Set S2SDS-12 (59622)
1/4
5/16
11/32
3/8
7/16
1/2
9/16
5/8
11/16
3/4
13/16
7/8
Deep Set S2DS-12 (58099)
1/4
5/16
11/32
3/8
7/16
1/2
9/16
5/8
11/16
3/4
13/16
7/8
This tool organizer was designed to fit three Icon socket sets. All the sockets are 3/8-drive, 6-point sockets. We included permanent laser-marked sizes between the rows. The deep sockets are on the left, semi-deep in the center, and shallow on the right. We cut the semi-deep and shallow sockets less deeply into the foam so you can easily grab the size you need. Impact sockets are larger and will not fit. The tool sets needed to fill this organizer are S2SS-12 (58103), S2SDS-12 (59622), and S2DS-12 (58099).
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
6-1/2 X 11-1/2 inches (inside width by inside depth)
Recommended for a drawer with at least 3-1/4 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
5-13/16 X 11-1/8 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.